Now back on the web page that opens a Mikrotik account, you click “All CHR Keys” on the CHR Licenses submenu. For example at level P1, then you will get a trial for 60 days or for 2 months. If there is already “done” written below, then the Mikrotik account is already connected. For the level, you can adjust it according to your needs, after all is filled, click “Start”. Enter your Mikrotik account afterwards, for those who don’t have a Mikrotik account, you can create one first at, and for those of you who already have a Mikrotik account, you just need to enter your account on. To check the license, you can click on “Renew License”. Open Winbox and enter the “System” menu, then go to the “License” menu. To check it, try opening, follow these steps: Unlike the existing license on the CHR, it is binding on the Mikrotik ID account. License and the router board license, it only binds to the software ID, so when buying a license, inform the software ID to the distributor. If you look at the speed limit column, the speed is Mbit, not Mbyte, if converted it might only be a few hundred bytes. However, the only difference is the speed. So you can configure all the features in Mikrotik. Licenses.license on CHR is basically the same as the license level 6 on X86 or on the Router Board. Kinds of Mikrotik License | IT and Technology Tutorials By Netdata. The Difference Between the Router Board. Now you can start the mikrotik CHR and connect to it via VNC xl create /etc/xen/chr. Replace the ip and mac address, you can use this Random MAC Address Generator to generate a new random MAC Address for the vm. # this is needed so that the system id does not change $ uuidgenĬraete a file /etc/xen/chr.cfg with the xen config builder = 'hvm' To create a unique uuid, run uuidgen and use this in the xen configuration below, thanks to the Mikrotik forum for this hint. Status: ERROR: This System ID is not valid for license Trying to purchase a license will give you this error: If you intend to buy a license for this CHR you need to make sure that yhe software-id does not change with every reboot, unforutnately the default setting would results in a new software id after every reboot, this would break the CHR license and you are stuck with 1Mbit. 
Download the mikrotik CHR raw image and unzip it wget ''Ĭraete a new LVM and copy the data from the image lvcreate -L 1G -n chr vg0ĭd if=chr-6.46.1.img of=/dev/vg0/-diskĬreate XEN configuration Generate new UUID
0 kommentar(er)
